Steam is introduced into the material layer inside the drum to increase the temperature of the granulation material, dissolve the salts of the granulation material, and achieve high liquid phase volume at low moisture content to meet the liquid phase volume required for material granulation, while reducing the evaporation water in the drying process. Ammonia can be added to the material layer inside the drum as needed to allow the material to react. The inner wall of the drum is lined with several soft rubber plates or polypropylene plates, and there are corresponding ventilation holes on the cylinder body. When the inner lining rotates from bottom to top along with the cylinder body, it will sag due to its own weight, causing the material adhered to the inner lining to fall down due to gravity, achieving the function of automatic cleaning of the material. During operation, operators can observe the formation of material balls at any time and take corresponding measures as needed to ensure the normal operation of the system.
Maintenance and upkeep of drum granulator:
1. The bearings bear all the load of the machine, so good lubrication has a great relationship with the bearing life. It directly affects the service life and operation rate of the machine. Therefore, it is required that the lubricating oil injected must be clean and the seal must be good. The main oil injection points of this machine are (1) rotating bearings, (2) rolling mill bearings, (3) all gears, and (4) movable bearings and sliding surfaces
2. Newly installed wheel rims are prone to loosening and must be checked regularly
3. Pay attention to whether the various parts of the machine are working properly
4. Pay attention to checking the degree of wear of easily worn parts and replace worn parts at any time
5. The base plane of the movable device should be free of dust and other substances to prevent the movable bearings from moving on the base frame when the machine encounters materials that cannot be broken, resulting in serious accidents
6. If the bearing oil temperature rises, it should be stopped immediately to check the cause and eliminate it 7. If there is any impact sound during the operation of the rotating gear, it should be stopped immediately for inspection and eliminated.
RSS | Website Map | XML
Copyright©2026 Zgfhfsb.com Tai an Hongxin Environmental Protection Sales Co., Ltd All Rights Reserved
Support:FEIXUN.CC