Fertilizer granulators are divided into various types based on the different raw materials they process, while compound fertilizer granulators have been developed based on different principles, including compound fertilizer drum granulators and compound fertilizer extrusion granulators. So what should we pay attention to when using these devices? How do we usually maintain and upkeep it? The editor of this article will share relevant knowledge with everyone.

The use, installation, and maintenance of compound fertilizer granulators are extremely important daily tasks that should be closely coordinated with the operation and maintenance of the machine. There should be dedicated maintenance personnel on duty to conduct inspections. 1、 Machine maintenance:

1. The bearings of the machine bear all the load of machine operation, so good lubrication has a great relationship with the service life of the bearings. It directly affects the service life and effectiveness of the machine. Therefore, it is required that the lubricating oil injected must be clean and the seal must be good. The main oil injection point of this machine.

(1) Rotate the bearing.

(2) Roller bearings.

(3) All gears.

(4) Active bearings and sliding surfaces.

2. Newly installed wheels are prone to looseness and must be checked regularly.

3. Pay attention to whether the various parts of the machine are working properly.

4. Pay attention to checking the degree of wear of easily worn parts and replace worn parts at any time.

5. The base plane of the movable device should be free of dust and other substances to prevent the movable bearings from moving on the base frame when the machine encounters unbreakable materials, which may cause serious accidents.

6. If the bearing oil temperature rises, the vehicle should be stopped immediately to check the cause and eliminate it.

7. If there is any impact sound during the operation of the rotating gear, it should be stopped immediately for inspection and eliminated. II Installation and test drive:

1. The equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts.

2. During installation, attention should be paid to the verticality between the main body and the horizontal.

3. After installation, check whether the bolts in each part are loose and whether the main engine compartment door is tightened. If so, please tighten it.

4. Configure power lines and control switches according to the power of the equipment.

5. After inspection, conduct a no-load test run. If the test run is normal, production can proceed.